Husky Baby Carrier Bedienungsanleitung

HuskyUser GuideP2219_R03.qxd 8/18/2004 11:04 AM Page 1

1716InstallationInstallationLap Belt Installation Short RouteFigure Aillustrates a typical short route lapbelt installation. WARNING: •Always use recl

1918Versa-Tether®Versa-Tether®WARNING:ATTACH THE VERSA-TETHER ONLY TO TETHERANCHORS IDENTIFIED BY YOUR VEHICLE MANUFACTURER ASTETHER ANCHORAGE POINTS.

2120Using Restraint FeaturesUsing the Buckle Fastening the Buckle1 Hold the buckle with one hand.2 Use your other hand to insert onetongue at a time i

2322Securing Your ChildSecuring Your ChildOnce the child restraint has beeninstalled in the vehicle, follow theseinstructions to secure your child in

The buckle has two positions andshould be adjusted to fit your child (Fig. D). Select the slot closest to, butnot under, the child.WARNING: Do not use

2726Care and MaintenanceCare and MaintenanceCover Removal 1 Loosen the harness, by lifting the harness release lever while pullingthe shoulder straps

2928Care and MaintenanceCare and MaintenanceCleaning the BuckleIf your child eats and drinks whilein the restraint, you may need tocheck the buckle pe

30WarrantyThis child restraint was manufactured by Britax®. Britax Child Safety, Inc. (“Britax”)warrants this product to the original retail purchaser

P2219_R03.qxd 8/18/2004 11:05 AM Page 34

P2219_R03.qxd 8/18/2004 11:05 AM Page 36

Table of ContentsSafety Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Safety Information . . . . . . . . . .

32•Use only with children who weigh between 22 and 80 pounds(10 and 36 kg) and whose height is 53 inches (134 cm) or less.•Snugly adjust the belts pro

54Safety InformationSafety Information• This child restraint system conforms to all applicable Federalmotor vehicle safety standards. This Restraint i

76Child Restraint FeaturesChild Restraint Features12534789101311116121 Cover2 Harness Slots3 Harness4 Comfort Pads5 Harness Retainer6 Chest Clip7 HUGS

8Vehicle Seating PositionsVehicle Safety BeltsNOTE: The information in this section onlyapplies to installation with vehicle seat belts. IMPORTANT: S

10 11InstallationLATCH InstallationFigure Aillustrates a typical LATCHinstallation. 1Verify that your vehicle is equippedwith LATCH anchors.• If LATCH

1312Installation5Verify that the vehicle belt is nottwisted, then buckle (Fig. D).6 While kneeling on the restraint to pushit firmly into the vehicle

4Verify that the vehicle belt isnot twisted, then buckle (Fig. D).5 While kneeling on the restraintto push it firmly into the vehiclebackrest, remove